Doing solar panels with nLite

I really like having the ability to move the jets in my nLite brush. I’ve set them wide today for doing solar panels.

Sent from my PG86100 using Tapatalk 2

if the pressure at the tap is high enough go with a quad spray set up also if you run a pump after your pure water to pole you can run a quad rinse set up. make sure those panels are off right? i usually have them check in/out put before and after i clean and wow in some cases where they have never been cleaned. i also take video and picture of before and afte to show home owner results.

make sure those panels are off right?

That’s good information. I didn’t know you should do this.