Zip Tie for Dogearring Affect

[SIZE=4]THERE IS NO NEED TO CUT OR BEND YOUR CHANNEL[/SIZE].
[SIZE=3]Using a piece zip tie cable tie will not only hold the squeegee rubber in.
It will give you the effect of dog earring the squeegee rubber.
Found that there are different thicknesses in Zip ties / Cable ties.
All you have to do is see which one fits your channel and squeegee rubber the best.
Also when putting in allow ½ inch to bend the zip tie at right angle for ease to pull out to replace squeegee rubbers.
The end that goes in the channel put a bit of a wedge at end, to get it to go in the channel in a bit easier.
Have tried it on Steccone,Quad Pro and Wagtail channels.
They all work.
And would also work in other channels as well.
ALL YOU HAVE TO DO IS GET A PACKET OF ZIP /CABLE TIES AND TRY IT, JUST HAVE TO FIND THE RIGHT SIZE/THICKNESS.[/SIZE]

[SIZE=5]Using Zip Tie to Dog Ear Squeegee Rubber[/SIZE]

//youtu.be/m3lW1-MtkAM

[FONT=tahoma][SIZE=4]
DIFFERENT WAYS TO DOGEAR SQUEEGEE CHANNELS / RUBBERS - YouTube[/SIZE][/FONT]

I found putting the zip tie on the under side as I did on the steccone channel.

That the squeegee rubber actually dog ears or curves slightly just try it you will see.

Found that with the Eureka Quad Pro squeegee channel did the same as you would have seen.

Only had these 2 types of squeegee channels to show how it was done.

However there would not be any reason that it would not work on other squeegee channels.

Hey H-Man,

I’m going to give it a try .

How you doing, good to see your videos !

Your Bro Dange