I haven’t gotten the Unger hydro power single stage out of the box yet and this fell into my lap.
This is where I’m employed, my GM asked I wanted to give it a shot with the DI system. The GM hasn’t ever seen this before with the water fed
Pole.
I could use some bidding advice. These windows have not been cleaned in about a year, very dirty .Any advise would be greatly appreciated.
.
Thank you
Quote it on how much you want to make for the time it’ll take.
I don’t know where you’re located or how the competitive landscape is, but I’d bid it at $5 per pane, exterior only, regardless of size. $7-$8 additional for each pane if they want the inside done too, because you may need a scissor lift. Don’t forget to “pass through” the cost of the scissor lift and it’s delivery to and from the job site. Your facility may have their own scissor lift, saving them that considerable cost.
Hope this helps!
Michael
Chief Spot Remover
SpotFree Window
510-214-3794
Unless you have extremely low TDS in your area, I mean like under 50, I would add another $100 to the bill for a new bag of resin. Those single stage Hydropures aren’t meant for heavy lifting. I use my single stage as a polisher, post RO.
I’d just trad pole it minus image 6426. Even then you can probably A ladder it or work on your pole skills. I haven’t had luck wfp’ing commercial.
