I seriously cannot develop an entire line of specialty abrasive products without you. We need to work together as a team. Here is a picture of my first batch of SRC pads. They are curing as I write, Once cured I will be sending them out to the first ten people who have signed up as Beta Testers. The back side of these pads have a velcro surface. So they can be added to any stain removal system out there. To use a pad just clean the window, then wet with clean soapy water, and start polishing. No more messy compound to apply from a bottle. The superabrasives are slowly released into the water from the pad where they do their work. Just the right amount are released. Then just soap and squeegee. Very simple.
Well I just got out of the hospital. Been there for almost a week. I figured I would test out a pad myself before sending 14 pads out to everyone. It worked perfect in that it released the superabrasive very well. Just as I wanted it to. And definitely polished the glass well too. The only catch was it left some very light scratches that were totally unacceptable. So I am going to tweak the “plastic formula” to see if I can eliminate this problem. The interesting thing is when I make up a highly dense compound with this particular silica superabrasive I do not get this problem. Same abrasive different carrier different results. So something I cannot explain is going on. Just want to fix this before I send out the samples.
