Guess everyone at the Big Convention will get to see this tool.
when is it going to be available
I’d like to know what angle adapter he was using
I think bob said next month it should be ready
What r u thinking about it luke? Is it like a wagtail or does it feel completly different?
Wasnt the endclips changed on this new channel?
Yes the end clips won’t fall off but they perform just the same. The tools does feel different from a wagtail…but if you’re experienced with a pivoting pole tool you should have no difficulties adjusting. The tool is much lighter and the pivot is much smoother and wider . The adjusting angles come in handy as well. One of my favorites is the design of the pad. It seems to have more pad on the glass than the wagtail and plus it’s very simple to remove. IT WON’T FALL OFF!!! One of the most annoying things about the wagtail. Over all I think you will be happy with this tool. I have not seen the finished product yet. The tool I tested was a prototype. There are a few bugs to be worked out but I’m sure guy at moerman and Bob are on top of it.
I must try it! Hope they gonna sell it here in Sweden.
The new Liquidator 2.0, does it not need clips? Wondering if I used it on a handle that doesn’t grab the rubber?
The rubber is held quite snugly but if you are using a handle without teeth you may need to firm the rubber up with some small bits of zip tie or paper clip. Remember, it’s designed to be used up with a toothed handle. I have noticed that you can purchase toothed plates for Ettore handles to retro fit on the standard channel handles.
