Wash It Pro items
I have been getting lots of calls from new owners of the Wash It Pro. I wanted to review a few items about this system that I think will help.
This unit is a 3 mode system. Always start with RO mode and check you TDS after the unit has run for 3-5 minutes.
If you can get spot free results with RO only this is the most economical way to work.
The red 26 inch hose is the waste water and connects to the off center male threads on the bottom of the filter.
The gray ball valve at 90 degree is the RO only pure water.
To clean using DI only attach the garden hose direct from water source to the inlet side of the gray housing on the front of cart. Connect your pole hose to the outlet side.
This unit will produce 0.6 plus or minus .25 gpm with a 4gpm min 20 psi water flow
The DI only mode will produce 3/4 gpm
There is a break in time for the RO membrane so over time it will flow better than when new.
The waste water flow is 1.25 plus or minus .25 gpm
Please feel free to contact me if you are having any problems with your unit.
Remember water temp has a big effect on RO production the colder the water the less production.
1 Like
I have been critical of the wash it pro, but one thing it does work well is situations with low water pressure.
We designed it with that in mind.
