Wanted to throw up a picture of a mod I did this morning. Loving the new clear dual trim from FoC, but honestly not a fan of the Sam Johnson fitting. So I simplified. I wish I had another T fitting instead of the Y- I would have put it directly between the other two T’s. I think I got this idea from Jeff Brimble or someone else on one of the UK forums.
Thanks :). I actually found a spare Tee. I’m not really worried about flow- I’ve got plenty. I really like not having anything near the lever for the whack adaptor.
Hmm, I noticed how it was kinking, but I hadn’t considered the o-rings. I’m going to switch out to a softer tubing and see if it will work better. If not, I’ll try and find some 90° elbows to make the turn
I use Rhino hose as jet connectors or all of my brushes. Perfect, really flexible and reduces flex on the jets and nuts in the brush block. Superb brush by the way, one of my favourites.
It’s a good quality brush. Doesn’t perform miracles or anything, but it has quite a bit of scrubbing power for a monofilament. The stiffer bristles are noisy when they touch the glass. Nice and lightweight, as well. Looking forward to see what Perry has for us next
@Infinity is this brush still working for you? I really like the way you set up the tubing. Very thoughtful of you.
I thought I was smart with my setup… back to the drawing board LoL!
I found some cheap plastic barb fittings on Amazon, I think (3/16"). IIRC, I trimmed them shorter with a razor to get the tubing as close to the jets as possible.